Solar-powered IR Sensor Instruction

Table of Contents

How to match the beams or any other solar wireless detectors with each type of system and how they work?

The solar-wireless infrared detectors can work with same brand wireless receiver at below steps:

Firstly: turn on the sensors

Secondly: set the alarm host into coding status

Thirdly: trigger the sensor, so the alarm host can remember the sensor

The active infrared beams can work with any other brand via our wireless to wired receiver. The steps of programming is different according to the alarm receiver instruction.

How to adjust the sensibility of the solar wireless beam detectors?

Unusual sensitivity will result in false alarm, such as free falling object. Infrared beam and infrared detectors' sensitivity can be adjusted according to using environment.

Adjust sensors’ sensitivity as follows:

A. PIR series:there is a Jumper inside--30S/120S(Item No. HB-T201;HB-T205)

B. Infrared detector series(Items those can be hand-made):

Regular sensitivity alarming time:200ms

(HB-T001S4;HB-T001S8;HB-T001Q3+;HB-T001Q4;HB-T001Q6;HB-T001Q8)

Regular sensitivity alarming time:100ms

(HB-T002A8;HB-T002S8;HB-T002S8-D)

Ways to adjust sensibility: restart the sensors(both transmitter and receiver)--long time press the receiver’s on/off button 10 seconds--after one beep--press the receiver’s on/off button 5 times(sensitivity time-200ms);press the receiver’s on/off button 6 times(sensitivity time--100ms)---OK

Ways to rematch the infrared light of the sensors: restart the sensors(both transmitter and receiver)--long time press the receiver’s on/off button 10 seconds--after one beep--press the receiver’s on/off button 4 times---OK